FAG Detector III - Page 42

42
Menu
Menu items and function
Send route/template
Sends one of the pre-selected routes/templates to the Detector.
Load data from
Detector
Opens a connection to the Detector and downloads all data stored in
the Detector.
Configure Detector
Allows to set all options to the Detectors registered.
Balancing activation
Enables the balancing function on the Detector.
Load Detector logfile
Retrieves the log file from the Detector and saves it.
Check for firmware
updates
Checks whether a newer Detector firmware version is available for
download.
Sensor
Adds , edits and deletes sensors.
Comment selection
list
Create and edit a list of comments.
Planning
Route
Creates and edits routes.
Template
Defines and edits configuration templates that can be used for free
measurements.
Service
E-Service
Sends selected data for further analysis.
Measurement report
Creates a measurement report.
Balancing report
Creates a balancing report.
Amplitude / phase
report
Creates an amplitude/phase report.
Run up / coast
down report
Creates a run up/coast down report.
Alarm report
Creates an alarm report.
Route report
Creates a route report.
Tools
Options
Program settings
Bearing DB
Opens the bearing database .
Deleting current
database
Deletes the Trendline database currently opened.
Start database
administration
Opens a program to administrate Trendline databases.
Save Trendline log
file
Saves the log file of the Trendline software.
Check for Trendline
updates
Checks whether a newer version of the Trendline software is
available for download.
?
Contents
Contents of the online help.
Index
Search index for the online help.
50
125
36
45
68
127
133
134
135
132
133
102
101
95
125
36