Fagor 8055 M - CHAPTER 7 ADDITIONAL PREPARATORY FUNCTIONS; 7.1 Interruption of block preparation (G04); 7.2 Dwell (G04 K); 7.3 Working with square (G07) and round (G05,G50) corners

Programming manual
CNC 8055
CNC 8055i
SOFT: V02.2X
·7·
CHAPTER 15 COORDINATE TRANSFORMATION
15.1 Movement in an inclined plane .................................................................................... 424
15.1.1 Definition of the inclined plane (G49) ....................................................................... 425
15.1.2 G49 in swinging spindles ......................................................................................... 430
15.1.3 G49 on Huron type spindles..................................................................................... 431
15.1.4 Considerations about the G49 function.................................................................... 432
15.1.5 Variables associated with function G49 ................................................................... 433
15.1.6 Parameters associated with function G49................................................................ 434
15.1.7 Programming example ............................................................................................. 435
15.2 Movement according to the tool coordinate system (G47) .......................................... 436
15.3 TCP Transformation (G48) .......................................................................................... 437
15.3.1 Considerations about the G48 function.................................................................... 440
CHAPTER 16 ANGULAR TRANSFORMATION OF AN INCLINE AXIS
16.1 Turning angular transformation on and off................................................................... 445
16.2 Freezing the angular transformation ............................................................................ 446
APPENDIX
A ISO code programming................................................................................................ 449
B Program control instructions ........................................................................................ 451
C Summary of internal CNC variables............................................................................. 455
D Key code...................................................................................................................... 463
E Programming assistance screens of the system. ........................................................ 473
F Maintenance ................................................................................................................ 477