Programming manual
120
CNC 8070
6.
TOOL PATH CONTROL
Arc defined by three points (G09)
(SOFT V02.0X)
110
Properties of the function
Function G09 is not modal, consequently, it must be programmed
every time when programming an arc defined by three points. After
executing it, the CNC restores the G01, G02 or G03 function that was
active before.
Function G09 may be programmed as G9.
Function G09 may not be used to programmed a full circle because
all three points must be different.
i
To Next Page
Loading...
