Programming manual
326
CNC 8070
12.
CYCLE EDITOR
Pre-emptied pocket
(SOFT V02.0X)
270
12.12 Pre-emptied pocket
Geometric parameters:
Roughing parameters:
The roughing operation empties the pocket leaving the following
finishing stocks:
Both stocks are defined as finishing parameters.
Xc, Yc Center of the pocket.
R Pocket radius.
r Pre-emptying radius.
Z Part surface coordinate.
Zs Safety plane coordinate.
P Total depth.
δ Finishing stock on the side walls.
δz Finishing stock at the bottom of the pocket.
To Next Page
Loading...
