CNC 8070
(SOFT V02.0X)
V
VERSION HISTORY
Here is a list of the features added in each software version and the manuals that describe them.
The version history uses the following abreviations:
Software V01.0x February of 2002
First version.
Software 1.1x September of 2002
INST Installation manual
PRG Programming manual
OPT Operation manual
Feature
Probe management through a digital input. It is not possible to manage it through the
“Counter” module connector.
INST
Set the numbering of the digital I/O. INST
Kinetics for rotary table. INST
Possibility to park and unpark SERCOS axes from the PLC. INST
Keyboard simulation from the PLC. INST
New treatment of the JOG panel (Key + Direction). INST / OPT
New machine parameters.
• Probe setting.
• Numbering of the digital I/Os.
• Kinetics for rotary table.
• Repositioning feedrate after a tool inspection.
INST
New variables.
• Probe setting.
• Numbering of the digital I/Os.
• Key simulation.
• Repositioning feedrate after a tool inspection.
• General scaling factor.
• Kinetics dimensions.
INST
PRG
General scaling factor (#SCALE). PRG
Pobring canned cycles (#PROBE). PRG
Probe selection (#SELECT PROBE). PRG
Programming of warnings (#WARNING). PRG
Block repetition ($RPT). PRG
Improved programming of high speed machining (#HSC). PRG
Improved programming of axis swapping (#SET AX, #CALL AX, #FREE AX, #RENAME). PRG
Macros: The number of macros in a program is now limited to 50. PRG
Improved tool table. OPT
Protection passwords. OPT
Manual mode (jog). Tool calibration with or without probe. OPT
Manual mode (jog). Automatic loading of zero offsets table. OPT
To Next Page
Loading...
