Programming manual
CNC 8070
ADDITIONAL PREPARATORY FUNCTIONS
Probing (G100)
8.
(SOFT V02.0X)
153
G102 - Exclude offset resulting from the measurement
Using this function, the CNC will ignore the probe offset to set the
theoretical axis position.
The exclusion of the offset is defined by programming function G102
followed by the axes whose offsets are to be excluded.
Programming G102 alone will cancel the offsets of all the axes.
Properties of the functions
Functions G101 and G102 are modal and incompatible with each
other.
On power-up, after an M02 or M30 and after an EMERGENCY or a
RESET, the CNC maintains the values programmed with G101.
...
G102 X Y (Exclude the offsets of the X and Y axes)
...
G102 (Exclude the offsets of all the axes)
...
To Next Page
Loading...
