Programming manual
210
CNC 8070
10.
CANNED CYCLES
G87. Rectangular pocket canned cycle.
(SOFT V02.0X)
202
7. Rapid withdrawal (G0) to the center of the pocket, 1 mm off the
machined surface.
8. New milling surfaces until reaching the total depth of the pocket.
• Penetration, at the feedrate indicated in "F" up to a distance "B"
from the previous surface.
• Milling of the new surface following the steps indicated in points
5, 6 and 7.
9. Withdrawal to the starting plane (Zi) if function G98 is active or to
the reference plane (Z) if function G99 is active.
To Next Page
Loading...
