Programming manual
210
CNC 8070
10.
CANNED CYCLES
G88. Circular pocket canned cycle
(SOFT V02.0X)
206
B Depth of pass.
If programmed with a positive sign (B+), the cycle recalculates
the step so all the penetrations are identical with the same
value as or smaller than the one programmed.
If programmed with a negative sign (B-), the pocket is
machined with the given pass (step) except the last pass that
machines the rest.
C Milling pass or width.
If not programmed or programmed with a 0 value, it assumes
a value of 3/4 of the diameter of the selected tool.
If it is the same as parameter "J" (pocket radius), it only runs
the finishing pass.
If programmed with a value greater than the tool diameter, the
CNC issues the relevant error message.
L Finishing pass.
If not programmed or programmed with a 0 value, it does not
run the finishing pass.
H Feedrate for the finishing pass. If not programmed or
programmed with a 0 value, it is carried out at the roughing
feedrate.
V Tool penetrating feedrate. If not programmed or programmed
with a 0 value, it is carried out at 50% of the feedrate in the
plane.
To Next Page
Loading...
