CNC 8070
Safety conditions
(SOFT V02.0X)
XIII
PRECAUTIONS DURING REPAIR
Do not get into the inside of the unit.
Only personnel authorized by Fagor Automation may manipulate the inside of
this unit.
Do not handle the connectors with the unit connected to AC power.
Before manipulating the connectors (inputs/outputs, feedback, etc.) make sure
that the unit is not connected to AC power.
SAFETY SYMBOLS
Symbols that may appear on the manual.
Symbols that the product may carry.
Symbol of danger or prohibition.
It indicates actions or operations that may hurt people or damage
products.
Warning symbol.
It indicates situations that certain operations could cause and the
suggested actions to prevent them.
Obligation symbol.
It indicates actions and operations that must be carried out.
Information symbol.
It indicates notes, warnings and advises.
i
Ground protection symbol.
It indicates that that point must be under voltage.
To Next Page
Loading...
