Programming manual
326
CNC 8070
12.
CYCLE EDITOR
Center punching
(SOFT V02.0X)
244
Basic operation:
1. It starts the spindle in the requested direction.
2. Rapid movement (G0), up to the XY point and the safety plane (Zs).
Depending on the starting plane, it first moves in XY and then in
Z or vice versa.
3. Rapid movement (G0) up to the approach plane.
4. Penetration at feedrate "F".
5. Dwell "t".
6. Rapid withdrawal (G0) up to the safety plane (Zs).
If it has a multiple machining operation associated with it, it executes
the following steps as often as necessary:
7. Rapid movement (G0) to the next point.
8. Repeats steps 3, 4, 5, 6.
To Next Page
Loading...
