Programming manual
326
CNC 8070
12.
CYCLE EDITOR
Pre-emptied pocket
(SOFT V02.0X)
272
Spindle turning direction (icon).
Clockwise with icon
(a)
.
Counterclockwise with icon
(b)
.
Machining direction (icon).
Clockwise with icon
(c)
.
Counterclockwise with icon
(d)
.
∆ Milling pass or width at the bottom of the pocket.
The cycle recalculates the pass so that all the passes are
identical, with the same value as or smaller than the one
programmed.
If programmed with a 0 value, it assumes a value of 3/4 of the
diameter of the selected tool.
N Number of penetration passes (steps) for the side finishing. If
the resulting step is greater than the cutting length assigned
to the table in the tool table, the step will be limited to that value.
Fz Penetration feedrate.
θ Penetrating angle.
The penetration is carried out along a helical path at the
feedrate set by finishing parameter "Fz" starting and ending at
the center of the pocket.
If defined with a value greater than the one assigned to the tool
in the tool table, it assumes the table value.
F Surface and side milling feedrate.
S Spindle speed.
T Finishing tool.
If programmed T=0, there is no finishing.
D Tool offset.
(b)(a)
(d)(c)
To Next Page
Loading...
