Programming manual
326
CNC 8070
12.
CYCLE EDITOR
3D pocket
(SOFT V02.0X)
290
3. Rapid movement (G0) up to the approach plane.
4. Roughing operation.
It is carried out in layers until the total depth is reached.
4.1. Penetration "I1" at feedrate "Fz" at an angle "β".
4.2. Milling of the pocket surface up to a distance "δ" from the
pocket wall. It is carried out at feedrate "F" and, if necessary,
it recalculates the pass (∆) so all the passes are identical.
It is carried out following paths concentric to the profile, in
the same direction as the outside profile was defined.
The islands are machined in the opposite direction.
4.3. Rapid withdrawal (G0) up to 1 mm off the machined surface.
5. Rapid withdrawal (G0) up to the approach plane.
6. It selects the pre-finishing tool and starts the spindle in the
requested direction.
7. Pre-finishing operation for the side walls.
It is carried out with the pass indicated by "I2" and at the pre-
finishing feedrate "F".
The outside profile in the same direction that was defined and the
islands in the opposite direction.
8. Rapid withdrawal (G0) up to the approach plane.
9. It selects the finishing tool and starts the spindle in the requested
direction.
10.Finishing of the side walls.
It is carried out with the pass "ε" and direction indicated by the icon.
Rapid withdrawal (G0) up to the safety plane (Zs).
To Next Page
Loading...
