Programming manual
326
CNC 8070
12.
CYCLE EDITOR
Surface milling
(SOFT V02.0X)
306
Spindle turning direction (icon).
Clockwise with icon
(e)
.
Counterclockwise with icon
(f)
.
Basic operation:
1. It selects the roughing tool and starts the spindle in the requested
direction.
2. Rapid movement (G0) to the roughing starting point and the safety
plane (Zs).
Depending on the starting plane, it first moves in XY and then in
Z or vice versa.
3. Rapid movement (G0) up to the approach plane.
4. Roughing operation.
It is carried out in layers, until reaching the total depth minus the
finishing distance "δz".
4.1. Penetration "I" at feedrate "Fz".
4.2. Milling at feedrate "F" and, if necessary, it recalculates the
pass (∆) so all the passes are identical.
In bidirectional milling
(a)(b)
, all the movements are at
feedrate "F".
In unidirectional milling
(c)(d)
, the movements between two
consecutive milling passes are carried out in rapid and at 1
mm above the part.
4.3. Rapid withdrawal (G0) up to 1 mm above the part.
4.4. Rapid movement (G0) to the starting point.
T Roughing tool.
If programmed T=0, there is no roughing.
D Tool offset.
(f)(e)
(c)
(a)
(b) (d)
To Next Page
Loading...
