Programming manual
CNC 8070
STATEMENTS AND INSTRUCTIONS
Programming statements
15.
(SOFT V02.0X)
423
The values of the call parameters may be defined in two ways. With
the parameter name P0, P1, P2, etc. or with the letters A-Z (except
the Ñ) in such a way that "A" is the same as P0 and "Z" is the same
as P25.
When using local parameters in the subroutine calls, besides
generating a new nesting level, it will also generate a new nesting level
for the local parameters; there may be up to 7 nesting levels of local
parameters within the 20 nesting levels of the subroutines.
Turning the function into non-modal
The modal subroutine is canceled with the instruction #MDOFF and in
the following cases:
• After executing an M02 or an M30 and after a RESET.
• When changing the work plane.
• When programming a probing move (G100).
• When modifying the configuration of the axes (#FREE AX, #CALL
AX and #SET AX).
• Call to a another subroutine (#PCALL, #CALL, L, LL, G180-189).
• Activating a canned cycle
#MCALL C:\Cnc8070\Users\Prg\sub1.nc
#MCALL C:\Cnc8070\Users\sub2.nc A12.3 P10=6
#MCALL Sub3.nc A12.3 F45.3 P10=6
To Next Page
Loading...
