Programming manual
CNC 8070
PROBING CANNED CYCLES.
Surface measuring canned cycle
16.
(SOFT V02.0X)
501
K Axis used to measure the surface.
Value Measuring axis
0 With the abscissa axis of the work plane.
1 With the ordinate axis of the work plane.
2 With the longitudinal axis of the work plane.
If not programmed, the canned cycle will take the value of "K0".
F Probing feedrate.
C It indicates where the probing cycle must end.
Value Meaning
0 The probe returns to the point from where the cycle was
called.
1 The cycle ends over the measured point. The
longitudinal axis returns to the coordinate corresponding
to the point where the cycle was called.
If not programmed, the canned cycle will take the value of "C0".
T Tool whose offset is to be corrected.
If not programmed, the CNC will interpret that it is the tool used
for machining.
D Number of the tool offset to be corrected once the
measurement is concluded.
If not programmed or programmed with a 0 value, the CNC will
interpret that the correction is not wanted.
L Tolerance to be applied to the measured error. It must be
programmed with an absolute value and the offset correction
will be applied only if the error exceeds that value.
If not programmed, the CNC will set this parameter to "0".
To Next Page
Loading...
