Fagor CNC 8070 - Page 8



 Programming manual
CNC 8070
(SOFT V02.0X)
ii
5.4 Tool number (T)................................................................................................................76
5.5 Tool offset number (D)......................................................................................................79
5.6 Auxiliary (miscellaneous) functions (M)............................................................................81
5.6.1 List of "M" functions ......................................................................................................82
5.7 Auxiliary functions (H) ......................................................................................................88
6. Tool path control
6.1 Rapid traverse (G00)........................................................................................................89
6.2 Linear interpolation (G01) ................................................................................................91
6.3 Circular interpolation (G02/G03) ......................................................................................95
6.3.1 Cartesian coordinates (Arc center programming).........................................................97
6.3.2 Cartesian coordinates (Radius programming) ..............................................................98
6.3.3 Polar coordinates ........................................................................................................101
6.3.4 Temporary polar origin shift to the center of arc (G31) ...............................................104
6.3.5 Arc center in absolute coordinates (G06/G261/G262)................................................105
6.3.6 Arc center correction (G264/G265).............................................................................107
6.4 Arc tangent to previous path (G08) ................................................................................108
6.5 Arc defined by three points (G09) ..................................................................................109
6.6 Helical interpolation (G02/G03)......................................................................................111
6.7 Electronic threading with constant pitch (G33)...............................................................113
6.8 Rígid tapping (G63)........................................................................................................115
6.9 Manual intervention (G200/G201/G202) ........................................................................117
6.9.1 Additive manual intervention (G201/G202).................................................................118
6.9.2 Exclusive manual intervention (G200)........................................................................119
7. Geometry assistance
7.1 Square corner (G07/G60) ..............................................................................................121
7.2 Semi-rounded corner (G50)...........................................................................................123
7.3 Controlled corner rounding, radius blend, (G05/G61)....................................................124
7.3.1 Types of corner rounding ............................................................................................126
7.4 Corner rounding, radius blend, (G36) ............................................................................130
7.5 Corner chamfering, (G39) ..............................................................................................132
7.6 Tangential entry (G37) ...................................................................................................134
7.7 Tangential exit (G38)......................................................................................................135
7.8 Mirror image (G11, G12, G13, G10, G14)......................................................................136
7.9 Coordinate system rotation, pattern rotation, (G73).......................................................139
7.10 General scaling factor ....................................................................................................142
8. Additional preparatory functions
8.1 Dwell (G04) ....................................................................................................................145
8.2 Software limits by program (G198-G199).......................................................................146
8.3 Hirth axes (G170-G171).................................................................................................147
8.4 OEM subroutines (G180-G189) .....................................................................................148
8.5 Changing of parameter range of an axis (G112)............................................................150
8.6 Probing (G100)...............................................................................................................151
8.6.1 Include/exclude probe offset (G101/G102).................................................................152
9. Tool compensation
9.1 Tool radius compensation ..............................................................................................157
9.1.1 Functions associates with radius compensation.........................................................158
9.1.2 Beginning of tool radius compensation.......................................................................161
9.1.3 Sections of tool radius compensation .........................................................................165
9.1.4 Change of type of radius compensation while machining...........................................169
9.1.5 Cancellation of tool radius compensation...................................................................171
9.2 Tool length compensation ..............................................................................................174