Hardware configuration.
CNC 8070
13.
OP-PANEL / OP-PANEL+SPDL RATE.
Hardware functionalities.
·246·
(REF: 1911)
24 V DC voltage supply.
Handwheel connection.
Connector data.
Number of poles. 3.
Pitch. 7.62 mm.
Connection technique. Screw connection.
Minimum/maximum tightening torque. 0.5 / 0.6 Nm.
Minimum/maximum section. 0.2 / 2.5 mm².
Minimum/maximum AWG section. 24 / 12.
Rated current In. 12 A.
Cable data.
Length to be stripped. 7 mm.
See "13.5 Power supply for the module." on page 244.
Connector data.
Number of poles. 10.
Pitch. 3.5 mm.
Connection technique. Spring connection.
Minimum/maximum section. 0.2 / 1.5 mm².
Minimum/maximum AWG section. 24 / 16.
Rated current In. 8 A.
Cable data.
Length to be stripped. 7 mm.
Plug-in part. 3-pole Phoenix-type combicon connector (7.62 mm
pitch).
Pin Signal. Function.
1Chassis.
2 GND 0 V reference signal.
3 +24 V Power supply.
1
Plug-in part. 10-pole Phoenix-contact minicombicon connector
(3.5 mm pitch).
Pin. Signal. Function.
1 +5 V 5 V DC voltage supply.
2 - - - - - -
3 - - - - - -
4 MPG3-B B signal of the third handwheel.
5 MPG3-A A signal of the third handwheel.
6 MPG2-B B signal of the second handwheel.
7 MPG2-A A signal of the second handwheel.
8 MPG1-B B signal of the first handwheel.
9 MPG1-A A signal of the first handwheel.
10 GND Power supply.
Cable shields must be connected to the ground plate. See "13.7 Handwheel connection." on page 249.
To Next Page
Loading...
