Hardware configuration.
CNC 8070
CNC-FPS. FAGOR-UPS (Q7-A PLATFORM ONLY).
16.
Securing the module.
·261·
(REF: 1911)
16.3 Securing the module.
When attaching the UPS, the following requirements must be met.
• Place the UPS in a vertical position.
• Place the UPS on profile 1, according to EN 60715 (NS 35) standard. Attach the modules
using two fastening caps (one on each side of the module) to immobilize the module.
• Always leave clearance around the UPS for ventilation and later handling. Refer to the
data sheet that comes with the product for further information on the assembly of the
UPS.
16.4 Protection fuse.
In order to protect the connected units, the UPS is fitted with a DC fuse in the battery
compartment. To protect the UPS during transport and/or prevent the accidental discharge
of the battery, the fuse is not installed at the factory. The fuse must be installed before starting
up the UPS. To insert or remove the fuse, follow these instructions.
1 Press the fastening buttons in the battery compartment.
2 Carefully remove the cover from the battery compartment.
3 Fit the fuse.
4 Reinstall the cover of the battery compartment.
One defective or blown fuse can only be replaced by another of the same type.
Do not remove the fuse and/or connection of the battery in HazLoc conditions.
To transport the UPS, the fuse must be removed.
To Next Page
Loading...
