FangLing F2500(A/B) - A2.1 Flame Cutting Timing Sequence; Appendix 2 Io Timing Sequence Figure of F2000 Series Numerical Control System

Appendix 2 I/O Timing Sequence Figure of F2000 Series Numerical Control System
119
Appendix 2 IO Timing Sequence Figure of F2000
Series Numerical Control System
A2.1 Flame Cutting Timing Sequence
Ignition
High Preheat
Low Preheat
TorchDn
TorchUp
Pierce1
Pierce2
Pierce3
Blow
Ignition time
Torch down time High preheat time
Low preheat time Pierce up time
Pierce 1 time Pierce 2 time
Pierce 3 time Pierce down time
Cutting
Blow time
Level 3 perforation timing sequence
with no THC
Torch
up
time
M07
M08
Note: Red words
mean output
port. Bold
black words
mean parameter.
Appendix fig 2.1 Flame cutting timing sequence (Level 3 perforation with no THC)