Chapter 7 Parameter Setting
51
Cutting Speed: the maximum cutting speed, unit is mm/m.
Manual Move Speed: the moving speed of cutting torch in manual, unit is mm/m.
G00 Move Speed: the cutting torch speed when G00 is executed or the cutting torch
go back to the reference or some other occasion, unit is mm/m.
Kerf: According to the cutting gap width, users set Kerf Gap compensation(the value
should be half of the cutting gap ) to ensure the dimensional precision, the system will
generate a new path automatically to make compensation to work piece. Before
cutting a work piece, you can modify kerf gap value, once begin to cut, you are not
permitted to modify the value.
Corner speed: Plate thickness affect the cutting tip’s ac/dc rate when it moving. The
angle between the end of a cut-point line’s
tangential direction
and the direction of the
tangent line of the beginning of next cutting point, and the thickness of plate
determines cutting tip speed at the transition.
If the normal cutting speed is V, angle is α, the proportion of corner speed is h, then
cutting tip speed in at the time of intersection is V
x
.
V
h
V
x
Notice: The unit is %mmpm. The max thickness of plate is 100, if more than 100mm
also are considered to be 100.
Cutting Type: There are two cutting types: Oxygen fuel gas and Plasma parameters.
You can press 【←】or 【→】to switch with them.
7.2 Flame Parameters
The oxygen fuel parameters, in Fig 7.2, control time delay in IO operation, and
whether use high adjustment.
To Next Page
Loading...
