Chapter 7 Parameter Setting
50
Chapter 7 Parameter Setting
In the main interface, you can get the parameter interface by pressing key【F4】
(Setups). The parameter function interface is showed in Fig 7.1
F1 Common F2 Flame F3 Plasma F5 System F6 Import F7 Export F8 Save
Max cutting speed 1000.000 mmpm
Manual move speed 3000.000 mmpm
G00 move Speed 1000.000 mmpm
Demo/back speed 2000.000 mmpm
Dust speed 1000.000 mmpm
Kerf value 1.000 mm
Corner speed(1-100) 100.000 % mmpm
Cutting type Flame <->
Demo Run Speed 1000.000 mmpm
F4 Powder
Fig7.1 Parameter Interface
You can set five kinds of parameter in the parameter interface:
1) Common parameters: cutting speed, manual move speed, G00 move speed, the size of
kerf gap, corner speed, cutting type, edge cut enable, hold preheat.
2) Flame parameters: all the parameters used in oxygen gas cutting
3) Plasma parameters: all the parameters used in plasma cutting
4) Powder parameters: ignition, perforation cycle parameters, dry dusting offset
5) System parameters: you can set system pulses, maximum speed limit, motor
parameters and soft limit parameters.
7.1 Common Parameters
It is the favorite’s parameters in Fig7.1.
To Next Page
Loading...
