FangLing F2500(A/B) - Dynamic Amplification; Cutting Exit

Chapter 3 Cutting Function
23
3.9 Dynamic Amplification
After the start of cutting, the F8 in the cutting interface will become "dynamic
amplification", then press the F8 key, full-screen amplify the processing graphic , and
dynamically tracking.
F8 ZoomInF1 Back F2 Demo
F4
Speeddown
F5
Speedup
F6
Preheatdown
F7
Preheatup
F3 GoBack
Fig 3.8 Function key of cutting interface
 Press the F8 key continuously, the system will progressively amplify graphic.
 Press ESC to exit the amplified display, back to the cutting interface.
3.10 Cutting Exit
When the cutting operation does not get finished, and the cutting machine also
being in the pause condition, if press 【Esc】, the system will query whether quit the
cutting operation. If pressing 【Enter】, the system will exit, and if pressing 【Esc】
the system will not exit, get into the automatically interface and go on with the cutting
operation at the current place.
FLSK F2200T
Version 3.3.71.1
Speed:
00000
File:
SHAPE_43.TXT
Status:
Stop
Current Line/Hole:
00000/00000
+X:500.00 -X:0.00 +Y:500.00 -Y:0.00
6: G01 X0 Y500.00
7：G01 X500.00 Y0
X：+000000.00
Y：+000048.70
Manual 【F】 ContiMov
StepDis【G】 5.00 Flame Cu 【M】
CutSpeed 【X】1000.00 Kerf【N】1.20
ManualSpeed【Y】3000.00 Angle 0.00
Quit of cutting?
ENTER: Quit
ESC: Continue cutting
●Ignition s
●LowHeat s
●HighPreheat s
●Pierce1 s
●Pierce2 s
●Pierce3 s
●TorchUp s
●TorchDn s
●THC En
●Blow s
F1 Back F2 Demo
F4
Speeddown
F5
Speedup
F6
Preheatdown
F7
Preheatup
F8
JumptoPierce
F3 GoBack
Fig. 3.9 Quit of cutting