FangLing F2500(A/B) - Remote Controller; Default Coordinate; Default IJ Coordinate; Option

Chapter 8 Diagnosis Function
72
8.7.6 Option
8.7.6.1 Remote Controller
F8 SaveF2 Output F3 AxesF1 Input F4 Motor F5 Option
Remote Controller Type
▌
No <>
Corridate Type: Relative
IJ coordinate type Relative
Default unit Metric
Fitting short line No
Steel angle remember No
F forbidden No
Save input angle as steel angle No
Press ←→ to change
Restart after change default unit
Fig 8.12 Option
Press left or right key in this interface, remote controller’s type can be set arbitrarily
one of the three types which are NO, P2P, 8421.
 NO type: no input of remote controller.
 P2P type: reference the section 11.1.2 Remote input.
 8421 type: reference the section 11.1.2 Remote input.
8.7.6.2 Default Coordinate
As the figure 8.12 shows, the default coordinate can be set default relative coordinate
or default absolute coordinate. The arc IJ coordinate can also set relative coordinate or
absolute coordinate.
8.7.6.3 Default IJ Coordinate
As the figure 8.12 shows, in the G code of G02 or G03, I or J parameter after the