Chapter 3 Cutting Function
17
3.2 Speed Regulation
3.2.1 Normal Speed Regulation
In automatic operation, or when the system is suspended, in the cutting interface
the system can regulate speed.
In the operation panel, press 【F5】, 【PRE】 or【HOME】, increasing 3% of
current rate with per click. Hold the 【F5】, 【PRE】or【HOME】, then the rate will
continuously increase to the maximal cutting rate.
In the operation panel, press 【F4】, 【NEXT】or【END】, decreasing 3% of
current rate with per click. Hold the 【F4】,【NEXT】or【END】, then the rate will
be continuously reduced to 0.5% of maximal cutting rate.
3.2.2 Quick Speed Regulation
In automatic operation, or when the system is suspended, in the cutting interface
the system can carry out quick speed regulation.
In the cutting interface, on the operation panel, press the number keys 【1】 -
【9】, the speed will quickly adjust to the corresponding percentage figures 10 times,
for example press 【3】, adjust to 30% of the speed limit you have set, press 【8】,
adjust to 80% of the speed limit you have set.
3.3 Forward
In the automatic function interface, press key
【
F2】，the machine start to move
without real cutting. The process does not include any ignition, perforation and any
other I/O working. The machine just moves the torch according to the graphic figure.
Press
【
F2】again, the system stops running.
The function can be used to check the trail and code before you start the real
cutting process, or can also be used when the process needs through the gun. Press the
red “STOP” key to stop the null cutting process if you want.
Forward speed and cutting speed are provided separately. Forward speed is
defined by the "empty / backward speed” in the common parameters.
To Next Page
Loading...
