Chapter 6 File Operation
47
press 【F3】 to delete the current line. Press 【F】 + 【Home】 key, the cursor
automatically moved to the first character of the current editing line, press the 【F】 +
【End】, the cursor automatically moved to last character of the current line.
Each edit line supports 128 characters maximum.
When you open a file on U disk or new a code file, you must save it as the local
machine code before you start cutting. Otherwise, you cannot make use of the breakpoint
recovery function or power off protection function.
After edit the code , press 【F8】to save the code.
6.5 New File
In the editing code interface (refer to 6.4 edit code ), you can press key【F4】to create
an new file to input your own code.
6.6 Compile Code
After create a new code or edit the code, if you want to know the code is valid or not ,
in the edit interface, press 【F1】,you can compile code to check whether the code is
correct.
6.7 Folder Manager
6.7.1 Select Work Folder
The system supports 10 folders, as the figure 6.1 shows.
Work folder: current work folder’s name.
0-/flash 1-DIR1 2-DIR2 3-DIR3 4-DIR4 5-DIR5 6-DIR6 7-DIR7 8-DIR8 9-DIR9
These 10 symbols interpret 10 folders’ names. The number in the first stands for the
short key, press the corresponding number, switch current work folder into corresponding
folder. For example, press【1】, it will show as the figure 6.6.
To Next Page
Loading...