FangLing F2500(A/B) - Page 24

Chapter 3 Cutting Function
15
 【F3】: Return to the starting point of cutting torch, i.e. the starting point of the
current work piece.
 【F4】: Decrease the cutting speed, each decrease of 1% click rate. Decrease the
rate of manual moving machine in manual mode.
 【F5】: Increase the cutting speed, each 1% increase in click rate. Increase the
rate of manual moving machine in manual mode.
 【F6】: Reduce the preheat time, skip the remaining preheat time, and the system
automatically records preheat time.
 【F7】: Increase the preheat time once 15 seconds.
 【F8】: When the system is suspended, for selecting perforation point; when the
system begins to move, for the dynamic amplification.
 Four direction keys (Up, down, left and right): When the gun through, manually
move the torch.