Chapter 8 Diagnosis Function
75
Function Update: after press 【F1】, it will update function. The function update file
is F2100B.exe or UserApp.exe.
Welcome Update: after press 【F2】, it will update the welcome interface. This
welcome interface is the first shown interface after power on. If you want to find the
method of make new welcome interface, please contact with our after-sale service
department.
Motion Update: after press 【F3】, it will update the motion. The motion update file is
MOTION.dsp.
System recovery: after press 【F4】, it will recover the system. At this time, the
system is exhaustively recovered back to the status before leaving factory, in other words,
the parameters, IO ports configuration, coordinate direction definition and so on are all
recovered back to the status before leaving factory. In the general condition, please don’t
use this function to recover this system.
To Next Page
Loading...
