RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3)
4-4
Reviewing LCD Messages (continued)
Message Cause Solution
Check Ribbon Error The print Ribbon may be jammed,
not installed properly, broken or
damaged.
Verify the Ribbon is
installed properly.
If jammed, clear it.
If broken, repair by
taping the Ribbon back
on to the take-up core.
Press RESUME to
continue or CANCEL to
reset the Printer.
Please clean your
Printer.
The Printer requires cleaning. For best Printer
performance, replace the
Cleaning Cartridge Tape
and clean the Printer’s
Feed Rollers and
Printhead at this time.
Refer to the Maintenance
section of your Users
Guide for fast easy
instructions.
Data Excess Error
OR
Job Data Error
The print or job data sent to the
Printer is corrupt or has been
interrupted.
Printer has stopped receiving data.
Check the interface cable
or cancel the print job and
resend.
Press RESUME to
continue or CANCEL to
reset the Printer.
EEPROM Erased An error was detected in the
Printer’s EEPROM structure and
the EEPROM has been erased.
Enter the factory Print,
Encoder and Transfer
settings into the LCD. The
factory settings are
located on the inside of
the Printer.
Continued on the next page
To Next Page
Loading...
