RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3)
5-21
Switching to the automatic IP address mode
Step Procedure
1
Select the Network link from any web page of the Printer.
2
Select the Obtain an IP address automatically radio button to enable the
DHCP/BOOTP, which automatically assigns the network settings.
Even with this button selected, the User can enter Stored Settings and the
Stored Settings will remain in memory. See below. (Note: This is the
default method.)
3
Click on the Submit button to save this setting.
4
Log in as a root User if you are so prompted. (Note: Any change of setting
will only be accepted after you have successfully logged in.)
5 Reboot the Printer to affect this change. See the procedures in Using the
Reboot pages.
To Next Page
Loading...
