RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3)
iii
Table of Contents
Section 1: Printer Overview _________________________________________________1-1
How to use the guide_________________________________________________________________ 1-1
Safety Messages (review carefully)______________________________________________________ 1-2
HDP600 Overview __________________________________________________________________ 1-3
Reviewing the HDP600 Block Diagram________________________________________________ 1-3
Reviewing the HDP600 Sequence of Operations _________________________________________ 1-4
Reviewing the HDP600 Boot up Sequence _____________________________________________ 1-7
Reviewing the Lamination Module Sequence of Operations ________________________________ 1-8
Reviewing the Lamination Module Boot up Sequence ___________________________________ 1-10
Section 2: Specifications____________________________________________________2-1
Table of Contents ___________________________________________________________________ 2-1
Safety Messages (review carefully)______________________________________________________ 2-2
Introduction________________________________________________________________________ 2-3
Reviewing the HDP600 Printer Overview table ____________________________________________ 2-3
Reviewing the HDP600 Package _____________________________________________________ 2-4
Reviewing the HDP600 (front)_______________________________________________________ 2-4
Reviewing the HDP600 CR100 Card Printer ____________________________________________ 2-5
HDP600 - Regulatory Compliances _____________________________________________________ 2-6
HDP600 - Agency Listings ____________________________________________________________ 2-6
Technical Specifications ______________________________________________________________ 2-7
Functional Specifications ____________________________________________________________ 2-14
Printer Components: Resin Thermal Transfer to USB Interface Port ________________________ 2-15
Printer Components: LCD and Softkey Control Pad_____________________________________ 2-17
Printer Components: Print Ribbons__________________________________________________ 2-22
Printer Components: Blank Cards ___________________________________________________ 2-23
Printer Components: Card Input and Output Hoppers____________________________________ 2-24
Printer Components: Card Output Hopper and Reject Hopper _____________________________ 2-25
Printer Unit: Reviewing the Card Lamination Module ___________________________________ 2-26
Printer Components: Transfer Roller_________________________________________________ 2-27
Reviewing the Overlaminates _________________________________________________________ 2-28
Reviewing the Thermal Transfer Film and PolyGuard Overlaminates________________________ 2-28
Reviewing the CR-90 or CR-100 Patch Size ___________________________________________ 2-29
Reviewing the Overlaminate Design _________________________________________________ 2-29
Section 3: Installation Procedures ____________________________________________3-1
Table of Contents ___________________________________________________________________ 3-1
Safety Messages (review carefully)______________________________________________________ 3-3
Introduction________________________________________________________________________ 3-4
Time Requirement ________________________________________________________________ 3-4
System Requirements ______________________________________________________________ 3-4
Inspection – HDP600 ______________________________________________________________ 3-4
Unpacking the Printer______________________________________________________________ 3-4
Choosing a Good Location__________________________________________________________ 3-5
About Moisture Condensation _______________________________________________________ 3-5
Printer Loading Procedures____________________________________________________________ 3-6
Loading the Print Ribbon ___________________________________________________________ 3-6
Loading clear HDP Film into the Transfer Station_______________________________________ 3-10
Inserting the Card Cleaning Cartridge ________________________________________________ 3-13
Loading the Overlaminate _________________________________________________________ 3-16
Connecting power to the HDP600 Printer _____________________________________________ 3-21
Loading the Blank Cards __________________________________________________________ 3-29
Printer Driver Installation Procedures___________________________________________________ 3-32
To Next Page
Loading...
Need help?
General
