FARGO electronics HDP600 - Section 10: Board Level Diagnostics_________________________________________10-1; Board Errors; Resolving the EE Checksum Error; Resolving the EE Memory Error

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3)
10-2
Board Errors
Resolving the EE Memory Error
Symptom: An error has occurred in the permanent circuit memory. (Note: The Printer’s
LCD will state the following: EEPROM ERASED.)
Step Procedure
1 Reboot the Printer.
2 If the problem persists, the Main Print Board will need to be replaced.
3 As an alternative to replacing the Main Print Board, the chip U21 may be
replaced. (Note: Fargo recommends that only a qualified electronics
technician perform this procedure.)
Resolving the EE Checksum Error
Symptom: An error has occurred in the permanent circuit memory.
Step Procedure
1 Reboot the Printer.
2 If the problem persists, the Main Print Board will need to be replaced.
3 As an alternative to replacing the Main Print Board, the chip U21 may be
replaced. (Note: Fargo recommends that only a qualified electronics
technician perform this procedure.)