RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3)
11-18
Adjusting the Transfer Speed
The Transfer Speed sets the baseline for the rate of image transfer and should not
be adjusted by the reseller or end user. If a different transfer speed is required, this
parameter may be adjusted via the Printer driver.
Setting the Printhead Resistance
Step Procedure
1 Locate the Printhead Setting Number on the bottom of the Printhead.
The number reads R=XXXX. Add Photo
2
Select MENU, Setup Printer, Print Settings and Printhead Resistance.
3
a. Input the Printhead Setting Number. (Note: The Printhead Resistance
setting in the LCD Setup changes in increments of 50.)
b. To select the proper resistance value, choose the setting that is closest to the
value on the Printhead.)
4
Press the Save button to save the value.
To Next Page
Loading...
