FARGO electronics HDP600 - Page 326

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3)
11-24
Adjusting the Flipper Offset
Step Procedure
1 Select MENU, Setup Printer and Flipper Offset.
2
Change the setting in small increments if the card is not feeding correctly. (Note:
A negative adjustment will lower the side of the Flipper Table closest to the Input
Hopper.)
There are five (5) settings under the Flipper Settings Menu:
 Mag/Prox
 Level
 Smart
 Inverted
 Home
See the Menu Tree in this section for their use. All settings can be tested from
this Menu.
3
Press the Save button to save the value.