Fargo HDP8500 - Page 86

HDP8500 Service Manual, PLT-01583, 1.1
© 2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
86
Step
Procedure
24
Careful when replacing the Printhead Motor Mount (D910052)
25
Replace Fan Box and all cables, Ethernet/USB Box, and Auxiliary Board.
Replace Covers in reverse assembly.
You have completed this procedure.
26
Open the Driver Toolbox then Advanced Settings. Change/verify the Printhead Resistance
value. This new value is stamped on the new printhead.