Fargo HDP8500 - Remove;Replace the Lamination Module Main Board (A940221)

HDP8500 Service Manual, PLT-01583, 1.1
© 2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
111
Remove/Replace the Lamination Module Main Board (A940221)
Tools needed: 10T Torx driver;
Estimated Time: 30 minutes
Preparation: Remove the Covers.
Important: This procedure can only be performed by
authorized service personnel.
Step
Procedure
1
Caution: Turn OFF the Printer and unplug the power cord from the Printer.
2
Remove all the Covers.
(Note: You do not need to remove the printer body to access the Main Board.)
3
Disconnect the cables from the Main Board.
Disconnect the Power Supply from the board.
Ensure all cables are labeled for reconnecting.
4
Remove the 5 screws (F000170) that hold to Board to the base. 1 screw holds the Power
Supply Cover.