FARO
®
Laser Scanner Manual
13
Chapter 4: Safety Precautions
• Do not bring metal objects or fluids into contact with the charger terminals.
The terminals may short circuit and generate heat in this condition.
• To avoid electrical shock, use the charger and the power supply unit in dry
indoor environments only.
• Do not operate the charger in an environment allowing exposure to
moisture, combustible fluids or gases. Danger of explosion!
• The charger should be kept in a dry room, out of the reach of children.
4.6 Mechanical Safety
• WARNING: The mirror unit rotates with high speed while scanning and for
a short period after the scan. While the mirror is rotating keep distance to
the product and do not touch the rotating mirror unit with your hands,
fingers or any objects at the risk of personal injury and damage to the
FARO Laser Scanner.
• The FARO Laser Scanner will rotate clockwise up to 360 degrees when
performing a scan. Ensure that the scanner head of the FARO Laser
Scanner can rotate freely and will not hit any objects during the scan.
• CAUTION: The FARO Laser Scanner may only be used when set on a flat
and stable surface. Injuries may result if the FARO Laser Scanner
overturns. Only use equipment recommended by FARO and follow the
setup instructions in this manual or in the manual of the manufacturer of the
equipment.
If using a cart, move the setup with special care. Never move the cart by
pulling the power cables. Pushing or pulling of the cart with too much force,
sudden stops, or an uneven surface can cause an upset of the FARO Laser
Scanner.
CAUTION:
Do not open the housing. By opening the housing serious personal injury
can be caused and you can damage the product.
•Only replacement parts authorized by FARO can be used according to the
instructions obtained from FARO. Do not use parts which have not been
supplied or recommended by FARO.
4.7 Transport
The following precautions must be taken when transporting the laser scanner
equipment:
• The laser scanner must be turned off during transportation or shipping in a
transport case.
• Remove the battery from the laser scanner before shipping.
To Next Page
Loading...
