FARO
®
Laser Scanner Manual
52
Chapter 6: Getting Started
6.8 Shutting Down the FARO Laser Scanner
To shut down the FARO Laser Scanner, press its Power On/Off button for 2
or 3 seconds or tap the Power button in the user interface drop-down list
under
Home. The top LEDs will start blinking blue. As soon as the
FARO Laser Scanner has finished the shutdown process the LEDs will stop
blinking and you can safely remove the battery and the power supply.
Pressing and holding the button more than 10 seconds will switch the
FARO Laser Scanner off without shutting down. Please use this option only if
the FARO Laser Scanner does not shut down regularly because of a
malfunction.
6.9 Powering Off the FARO Laser Scanner
Once the FARO Laser Scanner has been completely shut down, remove the
battery and secure the equipment in protective cases.
1. Open the battery compartment cover.
2. Release the interlock mechanism of the charger to release the battery.
3. Remove the battery.
Close the battery compartment cover.
Battery charging, deep discharge flashes red
Unknown power source. Battery and
AC adapter are not detected
constantly red
Scanner Status LED next to the battery
Caution
Damages to the scanner‘s internal PC and loss of
data.
Do not turn off the power of the FARO Laser Scanner
before the shut down cycle is complete.
The FARO Laser Scanner has an integrated PC with a
hard drive. This internal PC must be shut down before
turning off the power supply. If the power supply is
disconnected or switched off without the FARO Laser
Scanner being previously shut down, it may damage the
internal PC and might lead to a loss of data.
If the FARO Laser Scanner has not been shut down
properly, the next boot process could take more time as
usual as the FARO Laser Scanner might check its hard
disk for errors.
To Next Page
Loading...
