Faro FocusM 70 - 6.7 LED Behavior

FARO
®
Laser Scanner Manual
51
Chapter 6: Getting Started
The Inclination in degrees is displayed in the header bar
The following inclination warning message is displayed if the current
inclination of the scanner is above 5°.
Strong scanner inclination
Inclination of the scanner is not within +/- 5°. This could result in slightly
inexact scan measurements.
Try to position the scanner so that its inclination is between +/-5°.To get
reliable measurements from the built-in dual axis compensator you should set
up the scanner with an inclination less than 5° before starting your next scan.
For this, you may use either a bubble inclinometer at the tripod or the
inclinometer screen. Tap this button to get to the inclinometer screen.
6.7 LED Behavior
Scanner Status LED at Power ON/OFF button
Scanner off, external power supply not
connected
off
Regular boot process flashes blue and fast
Battery operation constantly blue
Power On/Off flashes blue
Scanner Status LED next to the battery
Scanner off, external power supply not
connected
off
Regular boot process flashes blue and fast
Battery operation constantly blue
Low battery operation at battery state
less than 10%
flashes blue
Low battery operation at battery state
less than 5%
flashes violet
AC adapter operation only (no battery) green
Battery charging, state of charge is
above 90% (charge done)
cyan
Battery charging orange
Battery charging, state of charge less
than 10%
flashes orange