FARO
®
Laser Scanner Manual
20
Chapter 6: Getting Started
Chapter 6: Getting Started
This chapter will provide preliminary steps and basic FARO Laser Scanner
operations and will guide you step-by-step from setting up the FARO Laser
Scanner to recording your first scan.
6.1 Charging the Battery
The Power Block battery can be charged in the FARO Laser Scanner or in the
FARO Power Dock battery charger. Carefully read the safety measures
described in
Power Block Battery Safety Measures and Power Dock Battery
Charger Safety Measures
before using them.
It is recommended to fully charge the battery before use. Please retain a spare
battery, if required, during your scan project.
The power supply unit can be used in many countries. It is compatible with a
100 V AC to 240 V AC 50/60 Hz power source. Use a plug adapter when
necessary.
6.1.1 Charging the Battery in the FARO Laser Scanner
1. Open the scanner's battery compartment cover.
2. Turn the battery so that its type label is directed upwards, point the battery
contacts to the scanner, push the battery straight in, and slide it downward
into the battery compartment until the fastener clicks into position.
DANGER
Danger of explosion or fire
• Do not immerse batteries into water or fire.
• Do not bring metal objects into contact with the battery
terminals. The terminals may short circuit and generate
heat in this condition.
DANGER
Danger of fire or electric shocks
Ensure that the devices are protected from rain or spraying
water.
• The power supply unit and the Power Dock battery
charger are not for outdoor use.
To Next Page
Loading...
