FARO
®
Laser Scanner Manual
137
Chapter 9: Maintenance
9.3 Cleaning of Strongly Contaminated Optics
9.3.1 Dry Pre-Cleaning (Non-Contact Cleaning)
Always start to remove dust or liquid droplet contamination on mirror or sensor
cover by using compressed dry air or special duster sprays (dry cleaning gas).
CAUTION:
Do not shake the Duster Spray bottle.
While using the duster spray, please ensure that you do not shake the bottle or
turn it overheads.
Figure 9-108: Dry pre-cleaning by compressed air or duster cleaning spray
WARNING
Hand injuries
If the scanner is accidentally switched on, the mirrors might
start to turn. Hence, before starting any cleaning activity,
• shut down the laser scanner module and remove the
battery pack.
• when using an external power supply, remove the power
line.
This will prevent the mirror from turning during the cleaning
work.
To Next Page
Loading...
