Introduction
CM-3202-11-I Installation and User Guide Revision 100
This document does not contain any export-controlled information.
Introduction
This guide is intended to help you physically install, configure settings for, and operate the CM-3202-11-I
indoor/outdoor mini-dome IP camera. The unit is a day/night camera with a 3MP 1/2.8” sensor and
includes an infrared (IR) cut filter. It supports three streams – Full HD 1080p, HD 720p, and D1 – with
H.264, H265, or MJPEG compression. The camera is powered by an 802.3af Power over Ethernet (PoE)
connection or 12VDC.
Figure 1: CM-3202-11-I Mini-Dome Camera
2.1 Features
• Progressive scan 3MP
1/2.8” CMOS sensor
• Triple stream: Full HD
1080p + HD 720p + D1
• Audio line in and out
• H.265, H.264, and MJPEG
compression
• 64-10Mbps bit rate • Alarm in and out
• Record snapshots and
video on 256GB
microSDXC card (not
included)
• Send snapshots on alarm
to FTP or 10 email
addresses
• IP67 enclosure with IK7 and
IK10 vandal-proof protection
• Tampering detection and
notifications
• Remote viewing via
RTSP on media players
• Motion detection event-
driven alarms
• SNMP v1/v2c/v3 and
SNMP traps
• 802.1X and SSL/TLS
security protocols
• Powered by 802.3af PoE
• Backlight compensation • Gamma correction • UPnP support
• Electronic day/night (ICR) • Shutter WDR • White balance
• ONVIF support • Digital WDR • 3DNR image noise reduction
• Two regions of interest • Infrared LED illuminator • Low-lux mode without IR
• 8 privacy zones • Built-in web server • Up to 9 users
To Next Page
Loading...
