FLIR Ariel CM-3202-11-I - Figure 71: Add Contact Screen; Figure 72: Contact Management

Configuration
CM-3202-11-I Installation and User Guide Revision 100
June 2020
59
This document does not contain any export-controlled information.
• TLS TTLS (Transport Layer Security or Tunneled Transport Layer Security): The mail server
requires TLS or TTLS authentication.
If you are not sure of the authentication the mail server requires for sending email or of any of the
following mail server settings, check with the email system administrator.
• Server Address: Specify the mail server’s IP address.
• Port: Specify the email server’s port number.
• User Name: Specify the user name for the mail server account.
• Password: Specify the password from the mail server account.
• Sender Email Address: Specify the email address of the account sending the alarm notifications.
• Attach Image: To attach the event snapshot to alarm notifications, move the slider to the right. By
default, images are not attached to alarm notifications.
Email List
You can specify up to 10 email addresses to receive alarm notifications.
To add a contact and enable alarm notifications
1. Click Add Contact. The Add Contact screen appears.
Figure 71: Add Contact Screen
2. Specify the contact’s Name and Email Address.
3. Move the Enable slider to the right.
4. Click Save. The contact is added to the Email List.
You can also:
• Modify the name and address of an existing contact
• Delete an existing contact
Figure 72: Contact Management
Changes to the Email List and to contacts in the list take effect immediately. To apply changes to other
settings on the Email page, click Save.