FLIR Ariel CM-3202-11-I - Change the Video Format (Optional); Figure 19: DNA - IP Setup Window; Figure 20: DNA - IP Setup Window - Status Ok

Installing and Connecting the Camera
CM-3202-11-I Installation and User Guide Revision 100
June 2020
19
This document does not contain any export-controlled information.
2. In the DNA Discover List, right-click on the unit and select IP Setup. The DNA - IP Setup window
appears.
Figure 19: DNA - IP Setup Window
Uncheck Use DHCP.
Specify the camera’s IP address, subnet Mask, and Gateway IP address.
It is possible to specify an IP address without changing the subnet.
Click Update.
The camera reboots with the new settings. Wait for Ok status to appear.
Figure 20: DNA - IP Setup Window - Status Ok
You can now access the camera’s web page using the IP address you specified.
3.7 Change the Video Format (Optional)
By default, NTSC is the camera's video format.
To change the camera's video format to PAL using the DNA tool
1. In the DNA Discover List, right-click the camera and select Change Video Format.