FLIR Ariel CM-3202-11-I - Motion Detection Configuration

Operation
CM-3202-11-I Installation and User Guide Revision 100
June 2020
39
This document does not contain any export-controlled information.
To delete a privacy zone
Select the privacy zone.
Under Zone Setting, click Clear. The privacy zone is immediately deleted. You do not need to click
Save.
For each privacy zone you want to delete, repeat the above steps.
4.9 Motion Page
On the Motion page, you can:
• Enable or disable motion detection
• Define the motion detection zone (also known as the region of interest)
• Configure the motion detection sensitivity
Figure 41: Motion Page
Note
If the camera is connected to a VMS that supports cell-based motion detection, FLIR recommends
using the VMS to configure the motion detection zone.
To enable motion detection and define the detection zone
Move the Enable slider to the right. By default, motion detection is disabled.
Specify the Sensitivity between 1-100, with 100 being the highest level of sensitivity and 1 being the
lowest.
Using your mouse, define the detection zone. You can:
• Click and drag on the Live View window to define a detection zone.
• Click once to add a single cell to the detection zone.
• Right-click once on a single cell to delete it from the detection zone.
• Right-click and drag to delete cells from the detection zone.
The detection zone appears as blue cells in the Live View window.
Click Save.