FLIR Ariel CM-3202-11-I - Alarm Page Configuration

Configuration
CM-3202-11-I Installation and User Guide Revision 100
June 2020
49
This document does not contain any export-controlled information.
Figure 55: SD Card Page
Overwrite (Reserve 20MB): When enabled and less than 20MB is available on the microSDXC card, the
camera overwrites recorded files. The recording program erases the earliest file and stores the new one.
By default, Overwrite is enabled. To disable it, move the slider to the left.
Status: Indicates whether a microSDXC card has been properly installed and mounted.
Encrypted Mode: When enabled, the camera encrypts the data it saves on the microSDXC card. To
enable Encrypted Mode, move the slider to the right.
Encryption Key (available when Encrypted Mode is enabled): Specify the key for encrypting and
decrypting files on the microSDXC card.
SD Format: To format a microSDXC card before using it, click Format.
Caution
Formatting a microSDXC card deletes all data on the card, regardless of whether it has been
encrypted.
Note
The card must be formatted as a single partition.
5.7 Alarm Page
On the Alarm page, you can create and configure alarm rules, including triggers, arming schedules, and
actions.