Installing and Connecting the Camera
CM-3202-11-I Installation and User Guide Revision 100
This document does not contain any export-controlled information.
3.6 Initial Networking Configuration
By default, DHCP (Dynamic Host Configuration Protocol) is enabled on the camera. If the camera
cannot connect to a DHCP server, the camera’s default IP address is 192.168.0.250.
• If the camera is managed by FLIR’s Horizon or Meridian VMS and the VMS is configured as a DHCP
server, the VMS automatically assigns the camera an IP address. That IP address appears in the
DNA Discover List.
• If the camera is managed by FLIR’s Latitude VMS or is on a network with static IP addressing,
manually specify the camera’s IP address using the DNA tool.
To manually specify the camera’s IP address using DNA
If this is the first time you are configuring the camera or if it is the first time after resetting the camera to
its factory defaults, DNA automatically authenticates the camera with the default password for the
camera's admin user (admin).
1. If the admin user password has been changed, you need to authenticate the camera.
In the DNA Discover List, right-click the camera and select Login.
Figure 17: DNA - Select Login
In the DNA - Login window, type the password for the admin user. If you do not know the admin
user password, contact the person who configured the camera's users and passwords.
Figure 18: DNA - Login Window
Click Login, wait for Ok status to appear, and then click Close.
In the DNA Discover List, verify that the camera's status is Authenticated.
To Next Page
Loading...
