FLIR Ariel CM-3202-11-I - Camera Configuration Options; Network Page Settings

Configuration
CM-3202-11-I Installation and User Guide Revision 100
June 2020
41
This document does not contain any export-controlled information.
Configuration
Users assigned the admin or expert role can click System Settings on the View Settings Home Page to
configure:
• Networking • FTP • I/O devices • Recordings
• RTSP • SD card • Sounds • Email
• Date and time • Alarms • Snapshots • Cybersecurity
• User accounts and
passwords
• Audio
In addition, users assigned the admin or expert role can access the Firmware & Info page to upgrade the
camera's firmware, reset the camera to its factory defaults, reboot the camera, and configure other
parameters.
5.1 Network Page
On the Network page, you can configure the camera’s networking settings.
Figure 43: System Settings Network Page - IP Mode Settings
Select the networking mode:
• DHCP: The camera is connected to a network with a DHCP server that assigns the camera its IPv4
Address, IPv4 Subnet Mask, and IPv4 Default Gateway.
• Static: Manually specify the camera’s:
o IPv4 Address: Identifies the camera on the network.