Installing and Connecting the Camera
CM-3202-11-I Installation and User Guide Revision 100
This document does not contain any export-controlled information.
3.3 Mounting Instructions
Follow the instructions in installation guides listed in the Related Information section of Package
Contents.
To directly mount the camera onto a wall or ceiling
Paste the included drill template onto the wall or ceiling where you are mounting the camera.
Figure 9: Drill Template
Drill three anchor holes according to the template.
Hammer the three plastic anchors into the drilled holes.
If the cable from the conduit does not enter on the side of the camera, drill a hole for cable entry
according to the template.
Using the Torx wrench, loosen the three Torx screws counter-clockwise.
Figure 10: Remove Camera Cover
To Next Page
Loading...
