FLIR Ariel CM-3202-11-I - Tls;Https; Figure 77: 802.1 X Settings

Configuration
CM-3202-11-I Installation and User Guide Revision 100
June 2020
64
This document does not contain any export-controlled information.
Figure 77: 802.1X Settings
802.1X is disabled by default. Before enabling 802.1X on the camera, you must register a user name
and password for the 802.1X server and configure the authentication server. Contact the network
administrator to obtain certificates, user IDs, and passwords.
To enable it, move the Enable slider to the left.
Protocol
Click TTLS (default) or PEAP.
CA Certificate: Click , and then browse for and upload the CA certificate for the
802.1X server.
Inner Authentication (available when the Protocol selected is TTLS): Select CHAP (default), EAP-
MSCHAPV2, MD5, MSCHAP, MSCHAPV2, or PAP.
User Name and Password: Specify the user name and password.
Anonymous ID (available when the Protocol selected is TTLS): Specify the Anonymous ID.
5.14.4 TLS/HTTPS
You can enable the Secure Socket Layer (SSL)/Transport Layer Security (TLS) protocol, which protects
camera settings and user name/password information. The HTTPS protocol uses SSL/TLS for secure IP
connections between the camera and a web browser over HTTP.
To use HTTPS on the camera, an HTTPS certificate must be installed. The HTTPS certificate can be
obtained either by creating and sending a certificate request to a CA or by creating a self-signed HTTPS
certificate. For more information, see Certificates
.