FLIR Ariel CM-3202-11-I - Figure 12: Adjusting the Camera Position; Figure 13: Desiccant Location

Installing and Connecting the Camera
CM-3202-11-I Installation and User Guide Revision 100
June 2020
15
This document does not contain any export-controlled information.
Figure 12: Adjusting the Camera Position
Caution
Note the limits for the three adjustment axes:
• Pan adjustment range : >360°
• Horizontal rotation range : ±175°
• Tilt adjustment range : 27°～ 90°
Place the desiccant in the camera.
a. Carefully tear open the vacuum-packed aluminum desiccant bag along the slit on one edge.
b. Remove the desiccant.
c. Remove the paper backing of the double-sided tape on one side of the desiccant.
d. Firmly attach the desiccant to the camera in the location shown.
Figure 13: Desiccant Location
Caution
• After placing the desiccant in the camera, attach the camera cover as soon as possible.
• To prevent condensation in the camera, tightly seal the mounts and conduits. Otherwise,
the desiccant will become damp and cannot be used.